It is currently Sun Jul 21, 2019 8:28 pm


Standard z22se supercharged M62 std. Pulley

Here you can post and discus calibrations which work well with your setup and ObdTuner.
  • Author
  • Message
Offline

hitman

  • Posts: 1
  • Joined: Fri Jan 03, 2014 9:58 pm

Re: Calibration for standard Z22SE engine

PostFri Jan 03, 2014 10:12 pm

Calibration details:
- Engine: stock Z22SE (no changes)
- Throttlebody: 68mm
- inlet: manifold with laminova cooling
- Exhaust: Dbilas 2.5" manifold + downpipe 200cell + exhaust
- Injectors: green lsj
- Rev limitter: 7000 rpm
- Cooling fan switch on temperature: 95
- Map sensor: 2 bar delphi
- Air temperature sensor: OEM
- Fuel pressure regulator connected to outside: boost
- EGR valve enabled: off
- Misfire check enabled: off
- Catalyst check enabled: off
- Main fuel alfa-n: Main fuel speed-density
- Supercharger: eaton M 62
- Supercharger pulley size: std
You do not have the required permissions to view the files attached to this post.

Return to Calibrations

Who is online

Users browsing this forum: No registered users and 1 guest

cron